Sunday, 15 July 2012

Shiny switch panel

Thanks to Steve getting me a nice shiny bit of aluminium I've created a blank panel that will go where the stereo used to be and will hold the extinguisher pull cord and cut off switch.

Anyone familiar with my CDT skills will be concerned at this point, so here is what I created:

You will notice that this is held in place by my finger.  This is a problem as the finger is required for other things, so I went to screw it in and realised it was not wide enough for the screws to reach the nuts in the dashboard.

So I made another one.  This one was wider and went behind the dash and actually fit.  If I say so myself I don't think it's that shabby...

Now it just needs some switches.

No comments:

Post a Comment